We had a lot of fun at our monthly class a couple of weeks ago. One of the projects we made was this gift card holder. Here are some photographs of what it looks like inside.
We used new products from the Stampin’ Up!® 2019/2020 Annual Catalog. The stamp set is called Good Morning Magnolia. This set is absolutely beautiful. It has matching dies called Magnolia Memory. The dies not only cut out most of the images in the stamp set, it also cuts the pieces for the flower we put on the band. The Designer Series Paper I used is called Garden Lane.
To make this card you will need the following sizes:
(1) 8 1/2″ x 8 1/2″ cardstock
(2) 3″ x 4″ Whisper White cardstock
(1) 3″ x 4″ DSP
(2) 1 7/8″ x 3″ DSP (to hold the gift card in)
(1) 4″ x 2 1/4″ DSP cut with the fancy die as close as possible to the edge
(1) 1″ x 7 1/2″ cardstock for the wrap
Plus you will need to cut out 2 of each petal size (I used Whisper White), one large flower center ( So Saffron) and 1 small flower center (Soft Suede).
To make this gift card holder you start out with a 8 1/2″ x 8 1/2″ piece of cardstock. I used Garden Green. Then you score it at 3 1/4″ and 6 1/2″ turn the paper 90 degrees and score again at 2 1/8″ and 6 3/8″. Your cardstock should look like this:
Then cut off the four corners so your cardstock looks like this:
Then you just stamp and decorate like the pictures above. The sentiment was punched out using the new Timeless Label Punch. The fancy edge on the top of the gift card holder is a die that is included in the Magnolia Memory die set.
I’m always looking for new Gift Card Holder ideas. Thank you for the directions.
You are very welcome!
Susan, this is wonderful. Thank you for sharing the instructions!
This is a beautiful card holder! Thank you so much for the measurements and instructions. I went straight to the craft room to make one.
What a fancy gift card holder! I love all of the folds. The magnolia stamp & die cut is beautiful!